Chelsea, AL

Delivered and installed a window air conditioning unit to the property. Positioned the unit securely in the designated window opening, ensuring proper fit and stability. Verified operational functionality and confirmed the installation met manufacturer specifications.

Completed installation of vent pipe and surge protector system. Properly routed and secured vent pipe to ensure adequate ventilation and code compliance. Installed surge protector to provide electrical system protection against voltage spikes and power surges.

Completed first service agreement visit for heating system. Inspected 4H4A heating unit which is not under our service coverage and confirmed system does not have UV light component installed. Documented equipment status and configuration for service records.

Responded to service call for blower malfunction. Upon arrival, diagnosed that blower motor was not receiving signal from control board. Troubleshot electrical connections and control board communication, identified faulty relay preventing blower operation, and restored system to normal working condition.

Completed installation of new American Standard gas furnace, PEAQ evaporator coil, and PEAQ heat pump connected to existing ductwork. Installed new thermostat, Aprilaire media kit with new media filter, full-size drain pan, and float switches. Verified existing electrical disconnect is functional and suitable for continued use.

Completed regular maintenance service on HVAC system. Unit was found to have no air conditioning function. Diagnosed the issue, performed necessary repairs to restore cooling operation, and verified system is now functioning properly.

Completed a drive-by inspection of the property to assess the HVAC system status. Confirmed that no air conditioning unit is present at the location during the regular service visit.

Responded to warranty service call for 4H4A unit covered under 12-month parts and labor warranty. Completed diagnostic trip to assess equipment condition and determine necessary warranty coverage actions.

Responded to service call for non-operational HVAC unit. Arrived on-site within estimated time window, diagnosed system failure, and restored unit to proper working condition. Completed routine service agreement inspection to ensure optimal performance.

Completed drive-by inspection to assess property conditions and gather preliminary information. Observed exterior conditions, documented relevant findings, and obtained necessary photographs for further evaluation and processing requirements.

Responded to service call regarding humidity issues and odor from vents. Inspected HVAC system and identified coil as source of odor. Cleaned evaporator coil, checked condensate drain for proper operation, and verified system humidity control settings were optimized for customer comfort.

Responded to service agreement call and identified air conditioning unit model 5H5A as equipment not serviced under current agreement. Determined unit ownership and service responsibility belongs to another provider or agreement. No service work performed on non-covered equipment.

Responded to service call for air conditioning unit tripping breaker upon startup. Diagnosed electrical issue causing overcurrent condition. Identified and resolved short circuit in compressor circuit, tested system operation, and verified breaker no longer trips during normal AC operation.

Performed comprehensive clean and check service on heating system under warranty coverage. Completed thorough inspection of all components, cleaned critical parts, and verified proper system operation. Unit is functioning within manufacturer specifications with no issues identified.

Completed final installation procedures and conducted thorough system verification to ensure all components were properly functioning and met operational specifications.

Completed routine Service Agreement Visit on 7H7A system with 10/10 warranty configuration equipped with UV light. Performed standard maintenance inspection, verified all system components operating within manufacturer specifications, and confirmed UV light functionality and proper operation.

Completed final installation procedures for equipment system. Performed comprehensive quality checks, verified all connections and settings, and ensured proper operation of all installed components before concluding the installation process.

Completed comprehensive system inspection on HVAC unit over ten years old to assess indoor air quality concerns and potential equipment failure. Performed diagnostic evaluation of all major components and determined equipment viability for continued operation or replacement recommendation.

Completed comprehensive turnover inspection on HVAC unit over ten years old and transferred case to Indoor Air Quality department due to age of equipment and potential system failure concerns. Unit assessed for possible equipment replacement needs based on condition and performance evaluation.

Completed first service agreement air conditioning maintenance visit. Performed comprehensive system inspection including filter replacement, coil cleaning, refrigerant level verification, electrical connection testing, and thermostat calibration. Confirmed unit operating within manufacturer specifications with no deficiencies noted.

Performed routine clean and check service on air conditioning system. Inspected all major components, cleaned condenser coils, checked refrigerant levels, tested electrical connections, and verified proper system operation. Unit is functioning within normal parameters.

Completed first service agreement visit for air conditioning system as scheduled Monday morning call. Performed comprehensive system inspection and preventative maintenance procedures per service agreement terms. Unit operating within normal parameters upon completion of visit.