Pelham, AL

Performed an indoor air quality turnover assessment and identified deficient attic insulation levels below recommended R-value standards. Documented the inadequate coverage and insulation depth as a contributing factor to thermal inefficiency and compromised air quality, and recommended supplemental insulation to restore proper thermal resistance and improve overall system performance.

I can't write an accurate job description from what was provided, because the service details contain only the title "Service Agreement Visit -" with no information about the work performed. The trade or system serviced, the tasks completed, and any problems found or resolved are all missing. Please share details such as the equipment or system serviced, inspections or maintenance tasks performed, parts or components replaced, and any issues identified and resolved. I will then write a concise, professional summary in the format you specified.

Performed a heating-season clean and check on a single heating system over 10 years old. Inspected and cleaned key components, verified safe and proper operation, and confirmed the unit is heating as intended.

Performed the second scheduled service agreement visit on the heating system, completing a full inspection and preventive maintenance in accordance with the service agreement. Verified system operation, confirmed the unit remains under active warranty coverage, and inspected the installed UV light assembly for proper function. System was left operating normally with no deficiencies noted.

Received compressor unit for service and logged under work order for evaluation and repair. Initial service call completed to inspect the compressor and begin diagnostic and repair procedures.

Performed a Service Agreement Visit on the heat pump system, including cleaning of the outdoor condenser unit. Removed accumulated debris from the condenser coil and fan guard using a brush attachment, then thoroughly flushed the coil with water to restore proper airflow and heat transfer. Inspected the compressor, refrigerant lines, and electrical components in the condenser cabinet, and noted standing water in the base pan following the rinse. Confirmed the system has a UV light installed.

Responded to a callback for a no-heat complaint and returned to the property to re-evaluate the heating system. Inspected the system's major components, including thermostat operation, ignition sequence, and airflow, to identify the cause of the heat loss. Completed the necessary corrective repairs and verified proper heating operation before concluding the visit.

Performed the second scheduled Service Agreement maintenance visit on two heating units, completing a full inspection and tune-up on each system. Verified proper operation, checked the UV light on the covered equipment, and confirmed all components were functioning within manufacturer specifications. Warranty coverage remains active, and the system was serviced with the customer's requested Parker equipment preference noted.

Performed the first scheduled service agreement visit on two heating systems, completing the seasonal heating maintenance and inspection on each unit. Noted that the equipment remains under warranty coverage and that no UV light is installed on the system.

Completed first scheduled protection visit on two heating systems covered under the 8-month installation warranty. Inspected both units, verified proper operation of equipment including the UV air treatment component, and confirmed all systems are functioning within normal parameters under the active warranty coverage.

Performed a scheduled service agreement visit on the heating system and air conditioning unit, both under active warranty. Completed the first seasonal heating maintenance inspection and verified proper system operation, and confirmed the air conditioning system is equipped with a UV light. Both systems were found operating within normal parameters.

Conducted a drive-by visual inspection of the property's corner lot to assess exterior conditions, including curb appeal, landscaping, and visible structural or site concerns. No immediate hazards or deficiencies were observed from the right-of-way, and findings were documented for the service record.

Performed a scheduled preventive maintenance protection visit, including a comprehensive inspection of the HVAC system's major components. Cleaned the condensate drain line, inspected electrical connections and the capacitor, checked refrigerant pressures and temperature differential, and verified thermostat operation. Replaced the air filter as needed and confirmed the system is operating within manufacturer specifications.

Performed a scheduled maintenance inspection on the packaged HVAC unit, including a visual check of the cabinet, electrical disconnect, conduit, and condensate drain line, all found intact with no signs of rust, frost, or damage. Opened the unit to inspect the compressor, refrigerant lines, capacitor, wiring, and condenser coil fins, noting algae and staining on the base pan and a loose zip tie near the wiring harness. Recommend maintaining clearance around the unit by trimming the surrounding shrubs and grasses to ensure proper airflow.

Performed a turnover indoor air quality (IAQ) service, including inspection of the HVAC system and air distribution components to verify proper operation and airflow. Addressed contaminants and air quality concerns through system cleaning and sanitization, and confirmed the system was operating efficiently and ready for occupancy.

Completed routine service agreement visit for HVAC system. Performed maintenance inspection on heating unit with 5-year, 7-month service history and air conditioning unit with 12-month warranty coverage that includes UV light system. Verified all equipment operational status and documented system performance.

Completed turnover and indoor air quality assessment on HVAC system with UV light installation to evaporator coil. System includes 7-ton heat pump (7H7A), 4-ton air handler (4H4A), and is under 12-month warranty. Verified proper operation of all components and UV system functionality following second service appointment for heating system evaluation.

Completed second service agreement heating maintenance visit on two heating systems (units 1H1A and 6H6A). Performed standard preventive maintenance procedures including filter inspection, burner analysis, heat exchanger examination, and safety control verification on both units. Noted that equipment is not under company's original installation and documented premium service agreement coverage with additional diagnostic checks.

Responded to no cooling call with blank thermostat display. Performed system analysis and safety check (SASC) to diagnose the issue. Identified power supply failure to thermostat, verified system components, and restored proper operation.

Conducted complimentary evaluation of a 9-year-old HVAC unit to assess current operating condition and system performance. Provided detailed equipment replacement estimate based on inspection findings and discussed available options with homeowner.

Completed second Protection Plan visit on a 4-ton heat pump system with 7-year-old evaporator coil that is currently 7 days out of warranty. Performed comprehensive inspection of 1-handle 1-action heating system operating at 7 hours runtime, confirmed all 12 points of the 12-point checklist, and verified system operation within manufacturer specifications.

Completed protection plan preventive maintenance visit on heating system. Performed comprehensive inspection and testing of two heating units with two air handlers, all equipment currently under warranty and equipped with UV light system. System operating properly following second seasonal maintenance appointment.

Removed and thoroughly cleaned the evaporator coil to restore proper heat transfer efficiency and system performance. Addressed accumulated debris and contaminants that were restricting airflow and reducing cooling capacity.

Completed turnover and commissioning of indoor air quality system. Verified proper operation of all IAQ equipment components and ensured system integration with existing HVAC controls. Conducted final testing and documentation to confirm system meets specified performance parameters.

Performed comprehensive clean and check maintenance on one HVAC unit of unknown age. Completed standard preventive maintenance procedures including system inspection, cleaning of components, and verification of proper operation. Unit found to be functioning within normal parameters upon completion of service.